HPE Community
BladeSystem - General
1753783 Members
7119 Online
108799 Solutions
New Discussion юеВ

Reseating OA reboots blade

 
8i5
Advisor

тАО03-05-2009 05:16 AM

тАО03-05-2009 05:16 AM

Reseating OA reboots blade

We have an issue where if the onboard administrator module in a C3000 is reseated one or more blade servers resets. You get a message in the OA log about power reduction being deactivated. I've tried disabling dynamic power mode but it does not help.

We're running firmware 2.25 ilo 1.60. Is this issue fixed in later firmware? I don't see anything in the fixes list to suggest so.
0 Kudos
Reply
4 REPLIES 4
JKytsi
Honored Contributor

тАО03-05-2009 08:16 AM

тАО03-05-2009 08:16 AM

Re: Reseating OA reboots blade

And I have seen manymany corrections between OA 2.25 and the latest 2.41. Are all problem fixes even reported.

But remember to upgrade ILOs first.
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
0 Kudos
Reply
8i5
Advisor

тАО10-05-2009 01:16 AM

тАО10-05-2009 01:16 AM

Re: Reseating OA reboots blade

We're on 2.41 and matching system bios/ilos but this still happens...
0 Kudos
Reply
JKytsi
Honored Contributor

тАО10-05-2009 07:49 AM

тАО10-05-2009 07:49 AM

Re: Reseating OA reboots blade

And the latest OA firmware is 2.60
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
0 Kudos
Reply
8i5
Advisor

тАО10-12-2009 01:52 AM

тАО10-12-2009 01:52 AM

Re: Reseating OA reboots blade

no doubt by the time we've updated to 2.60 to see if that helps, HP will have release 2.61.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.