HPE Community
BladeSystem - General
1752812 Members
6227 Online
108789 Solutions
New Discussion юеВ

Re: Speed/Duplex greyed out via HP Network Config Utility

 
Lisa Paxton
Advisor

тАО04-02-2008 07:38 AM

тАО04-02-2008 07:38 AM

Speed/Duplex greyed out via HP Network Config Utility

Hi There

I understand that the Speed\Duplex of a Blade server is determined by the configured speed set via the Passthrough module. Is there no way you can physically amend the Speed via the configuration utility so that it actually shows 1000/Full rather than Auto/Auto?
0 Kudos
Reply
3 REPLIES 3
JKytsi
Honored Contributor

тАО04-02-2008 08:18 AM

тАО04-02-2008 08:18 AM

Re: Speed/Duplex greyed out via HP Network Config Utility

Passthrough module does not do anything, it just passes the signal from blade nic to outside chassis.

Blade NIC "speak" only with 1Gb
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
0 Kudos
Reply
John.Horton
Frequent Visitor

тАО08-18-2008 09:41 AM

тАО08-18-2008 09:41 AM

Re: Speed/Duplex greyed out via HP Network Config Utility

Hi, I am looking for a solution to this issue as well. I have a client that needs to change the port speed for his "Heartbeat" on his cluster servers. apparently, best-practice is to throttle down to 100Mb. Are we stuck with making this change at the Network Switch level???

Thanks,
JOHN
0 Kudos
Reply
JKytsi
Honored Contributor

тАО08-18-2008 10:38 AM

тАО08-18-2008 10:38 AM

Re: Speed/Duplex greyed out via HP Network Config Utility

Blade NIC is only 1GB
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.