HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Stacking Link FAILED

 
Jafiz Nazim
Occasional Advisor

Stacking Link FAILED

One of my c3000 VC staking link status is showing as FAILED and Redundancy Status:No Redundancy.

Could any one pls help me to fix this issue.
6 REPLIES
JKytsi
Honored Contributor

Re: Stacking Link FAILED

You have only one VC module ?
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
Jafiz Nazim
Occasional Advisor

Re: Stacking Link FAILED

1 have two VC'c
JKytsi
Honored Contributor

Re: Stacking Link FAILED

well ...are the modules stacked ? = connected to each other with 10Gb or 1Gb cable.
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
Jafiz Nazim
Occasional Advisor

Re: Stacking Link FAILED

Yes it stacked through X0 port......
JKytsi
Honored Contributor

Re: Stacking Link FAILED

and what link it says failed ? There is horizontal stacking between modules but on c3000 that's not possible (all embedded NICs go to interconnect bay1).
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
JKytsi
Honored Contributor

Re: Stacking Link FAILED

So ... ?
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi