HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Temp warnings on P-Class Blades

 
Koopa
Frequent Advisor

Temp warnings on P-Class Blades

I've had a over temp warning on a blade which points to one of the 3 phase power enclosures. Could someone please confirm what the correct temps should be, for blades and chassis. So i know if the snmp trap is maybe reporting at too low a level.

Thanks

Koopa