HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Unable to log into c7000 OA after firmware update

 
Jim Davis_8
Occasional Advisor

Unable to log into c7000 OA after firmware update

Have just been looking at our C class OA's and found that one of them at firmware Version 1.20 and the other at version 1.01. Simply applying a firmware update fails when the 2 OA's are mismatched. I had to physically remove the later version OA from the enclosure and flash it up to the same version as the other. Reinserted the other OA and I then had a redundant pair without erros being logged. I was then able to flash both OA's up to version 1.30 as per normal procedure.

My dilemma is this... The factory default password no longer works and so I cannot log into the OA modules anymore. iLO2 is still accessable just not the OA's. Is it possible that the firmware has changed the password???

Regards

Jim
2 REPLIES
Oleg Koroz
Honored Contributor

Re: Unable to log into c7000 OA after firmware update

Jim Davis_8
Occasional Advisor

Re: Unable to log into c7000 OA after firmware update

Oleg

Thankyou sir. Done well.