HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Understanding Blade ILO Network Settings

 
Dan_394
Advisor

Understanding Blade ILO Network Settings

Hi,

Can someone please explain why each blade in my c7000 enclosure has an ILO network speed/duplex setting? Given that only the OA on the c7000 has a physical connection and individual blades don't have physical connections?

Thanks
Dan
1 REPLY
Adrian Clint
Honored Contributor

Re: Understanding Blade ILO Network Settings

Because its the same firmware as the firmware in rackmount servers, where this setting is important.
Just ignore it.
As I understand it there is effectivly a network hub in the backplane. The OAs, interconnects and iLOs all connect to this "hub".
So any setting you make is between the iLO and the hub. As its set to run at the best speed - no need to change it.