BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Usage of nc360M Ethernet module for Cluster Interconnect

 
Habich
Occasional Advisor

Usage of nc360M Ethernet module for Cluster Interconnect

I want to build a solaris cluster between to blades in an enclosure. my solaris installation has found 2 ethernet interfaces (e1000g0, e1000g1) which i want to use for 2 cluster interconnects.

How do i have to configure the virtual connect manager to get a network connection between the two blades?
2 REPLIES
JKytsi
Honored Contributor

Re: Usage of nc360M Ethernet module for Cluster Interconnect

Create a network without any uplinks. then map that network to NICs which You want to use in cluster traffic.
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
The Brit
Honored Contributor

Re: Usage of nc360M Ethernet module for Cluster Interconnect

As pointed out by Jarkko, create a VC "Ethernet Network" but do not assign any ports to it.
Then in the server profile, assign this "clustering" network to the Port(s) which you want to use.

Dave