HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

VC-FC Module - how to delete in Virtual Connect Manager?

 
SOLVED
Go to solution
PArevalo
Occasional Advisor

VC-FC Module - how to delete in Virtual Connect Manager?

I used to have a VC-FC Module inside interconnect bay #3 and recently replace it with 2 pass-thru FC modules in Bay 3 and Bay4.

The c7000 OA correctly identified the new FC pass-thru modules. However the Virtual Connect Manager still reports that interconnect bay 3 has the VC-FC module with a major error. I'm unable to delete the previousely defined SAN Fabric even if I tried reseting the VC Manager.

I'm not sure if anybody else have encountered a similar problem. Thanks for any suggestions that you can provide.
3 REPLIES
JKytsi
Honored Contributor
Solution

Re: VC-FC Module - how to delete in Virtual Connect Manager?

updare your virtual connect FW to 1.32. Then You can remove components from VC domain
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
PArevalo
Occasional Advisor

Re: VC-FC Module - how to delete in Virtual Connect Manager?

Thanks Jarkko, that resolved this issue!
PArevalo
Occasional Advisor

Re: VC-FC Module - how to delete in Virtual Connect Manager?

The solution provided requires that after the firmware updates, you will need to physically remove the module before the "remove to VC domain" button becomes available.

You will also need to reset the affected interconnect bay module before it appears and registers correctly on the VC Manager.