HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

VC Flex10 uplink cables...

 
Louis Henninger_1
Regular Advisor

VC Flex10 uplink cables...

We've started to implement VirtualConnect Flex10 into our C7000 blade system. The quickspecs for VC Flex10 (Dated july'10) indicated that Cisco cables were compatable.
We have only been successful in getting the HP Branded cables to work. Additionally the later quickspecs for the VC Flex10 doesn't specifically say Cisco cables would work, as before. What's up? We are running version 3.1 on VC Flex10 modules.

Thanks,

Louis
2 REPLIES
Louis Henninger_1
Regular Advisor

Re: VC Flex10 uplink cables...

Found solution to problem....when we updated to VC version 3.1, problem was fixed. We hadn't tested the connectivity with the Cisco cables again until today.

We updated the VC firmware in order to use the VC Flex10 modules is Bays other than 1 and 2 as was the case with an earlier version of Firmware.

Louis Henninger_1
Regular Advisor

Re: VC Flex10 uplink cables...

See above post...may help someone else...

Regards,

Louis