BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

VC flex10g Ethernet uplink faild

Adel Elamin
Frequent Advisor

VC flex10g Ethernet uplink faild

Dear ITRC
I'm installing C7000 with 10 BL460c G6.
I want to configure 4 uplinks from VC flex10g Ethernet to be used in a single network. I have connected (Bay 1 port X1, Bay 1 port X2, Bay 2 port X1, Bay 2 port X2) to my DC switch and when ever I try to run the network set-up wizard it show my connected links are Not linked al though they are connected to my local switch and my local switch is working properly.

please see the attachment and advice

Regards
Adil Elamin
6 REPLIES
Adel Elamin
Frequent Advisor

Re: VC flex10g Ethernet uplink faild

please find the attached system logs
Note: on 11-2010 the configuration made by HP (factory integrated)
however after I logged to the VCM the previous setting have been lost

Regards
Adil
Adel Elamin
Frequent Advisor

Re: VC flex10g Ethernet uplink faild

Hi
I tried to connect one VC physical uplink port directly with my laptop and it come up, but the link never come up when ever I connect it to my DC switch cisco 2950.

Regards
Benoy Daniel
Trusted Contributor

Re: VC flex10g Ethernet uplink faild

what about the physical link connectivity status at Flex 10?. Is it shows link up?
Adel Elamin
Frequent Advisor

Re: VC flex10g Ethernet uplink faild

No!
it show up when ever I connect the physical link to another device, but it show down whenever I connect it to my DC switch.
I think VC will operate only with 100MB/S switched network and higher only.

Regards
Adil
Benoy Daniel
Trusted Contributor

Re: VC flex10g Ethernet uplink faild

Yes.. VC is not supported at 10Mbps level.
The Brit
Honored Contributor

Re: VC flex10g Ethernet uplink faild

More specifically, 10Mb/s is not supported on Flex10 VC module.

It is supported on the older 1/10g VC modules.

Dave.