BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

[VIRTUAL CONNECT] Change default gateway

 
Danilo B
Frequent Advisor

[VIRTUAL CONNECT] Change default gateway

How do I change interconnect bays default gateway on a C-Class Enclosure? I cannot find any place to set default gateway into Virtual Connect Management interface. I tryied to change it using Enclodure Blade IP Addressing on OA but with no success

Thank you all for help
2 REPLIES
The Brit
Honored Contributor

Re: [VIRTUAL CONNECT] Change default gateway

Not sure what you mean by VC Management interface. There is an "Enclosure" Management interface which allows communication between the OA's and the Device Bay ILO's and Interconnect Bay Modules. It is not specific to VC. I am not aware of a specific VC management interface.

Anyway, the "Enclosure" management default gateway is set under EBIPA>Device Bays (or Enclosure Bays) tab. You must press "Apply" after making a change.

Also, Device Bays, IC Modules and OA's must be on the same subnet, which means they all use the same default gateway, so they should be set the same.

Hope this helps.

Dave
Danilo B
Frequent Advisor

Re: [VIRTUAL CONNECT] Change default gateway

SOLVED! I had to change default gateway on 'Device Bays' tab and also on 'Interconnect Bays' tab. Previously I changed only on 'Interconnect Bays'

Thank you for help!