- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- VLAN definitions in HP StorageWorks SB600c
BladeSystem - General
1753867
Members
7168
Online
108809
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-15-2009 02:17 AM
03-15-2009 02:17 AM
VLAN definitions in HP StorageWorks SB600c
A customer is implementing an HP StorageWorks SB600c with Windows 2003 Stoarge Edition. Using the HP Network Configuration Utility, the two embedded NICs have been defined as a TLB team. They would like to set up two VLANs over this team, one for iSCSI traffic and a second for management traffic. They add a VLAN on the team using the HP NCU. The NCU shows the new VLAN; however, no interface appears under Windows to allow the assignment of an IP address for this VLAN.
Is something missing to allow the addition of VLANs?
Is something missing to allow the addition of VLANs?
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-15-2009 11:58 PM
03-15-2009 11:58 PM
Re: VLAN definitions in HP StorageWorks SB600c
when you assign vlan's you need to assign ALL vlans in NCU.
The "root"-NIC is not used anymore.
Hence when you configured the first vlan you only got a single operational NIC.
You must configure a second vlan in NCU to get two NIC's (even if this is vlan1).
hope this helps
Pieter
The "root"-NIC is not used anymore.
Hence when you configured the first vlan you only got a single operational NIC.
You must configure a second vlan in NCU to get two NIC's (even if this is vlan1).
hope this helps
Pieter
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP