HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

VLAN tagging and tunneling mode on one Shared Uplink Set

 
SOLVED
Go to solution
Andrew_Read
Frequent Advisor

VLAN tagging and tunneling mode on one Shared Uplink Set

I would like to be able to setup server tagging for VMware and network VLANs for Windows servers on the same uplinks.

A post from last December mentioned this functionality is planned for a future firmware release.

Does anyone know if this is available yet (or an ETA)?

Regards,

Andrew
3 REPLIES
Lmm_1
Honored Contributor
Solution

Re: VLAN tagging and tunneling mode on one Shared Uplink Set

It should be included on version 1.31, the release will be in a few weeks.

rgds,
Lmm
Andrew_Read
Frequent Advisor

Re: VLAN tagging and tunneling mode on one Shared Uplink Set

Thanks for the response.
Andrew_Read
Frequent Advisor

Re: VLAN tagging and tunneling mode on one Shared Uplink Set

Closing thread