Virtual Connect 3.01 and BL685G6s Where is LOM3a and 4?

[kheller2]

Using VC 3.01 on a 7000 chassis, I no longer can see how to assign networks to LOM3 and 4 in the profile settings. I can only set up LOM1 and 2.

This was working fine in the previous version of VC, but the new version is not as fast or nice.

[Michael Leu]

In the profile screen of you BL685G6 you have to click on one of the existing LOMs and then right click -> add.

> but the new version is not as fast or nice.
That's a very polite way of putting it ;-)

[kheller2]

You're kidding? I miss the old table view from prior to this, especially when clicking on "assigned profiles".

HP.. you need a consistent and good UI. I have a few books you could borrow.

Now.. on to my next issue...

When disabling the ASR from hpasmcli..
ERROR: Failed to get ASR enabled state.

[Michael Leu]

So did it work?

Yeah sadly they aren't kidding with this UI.. they probably had too much trouble with supporting customers who have IE6 only, so they moved to flash. :-(

[kheller2]

yes that worked, thank you. Since when do you right click on a web interface? 2.33's web interface was better. :) This flash stuff is slow and rather annoying. I feel a changing of the guards at HP.

Mind you none of this stuff works correctly on Safari on a Mac (I think there is a bug with regards to that in the web engine).