HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Virtual Connect FlexFabric 10Gb/24-Port Module VSAN Trunking

 
Assaf Feuerstein_1
Regular Advisor

Virtual Connect FlexFabric 10Gb/24-Port Module VSAN Trunking

Hello Everyone,

I have a quick question about the Virtual Connect FlexFabric 10Gb/24-Port Module, i have this module for a POC.

I connect this module to a Cisco MDS 9509.

Until so far i have found in the documentation and the internet that this module acts in NPIV mode. My question is if there is a way to config this module to act as a switch and if it supports VSAN trunking at all? also does it support port-channeling?

(This blade center is not operational yet so i havnt seen whats on the configuration of this module :) )
1 REPLY
Steven Clementi
Honored Contributor

Re: Virtual Connect FlexFabric 10Gb/24-Port Module VSAN Trunking

No.

The module is not a switch. It will not act like a switch.

I JUST installed one of these for a POC, but I don't remember if the Fibre ports aggragate up since we only had 1 port per switch to use. I know the network ports suport LACP.

I'll be going back on site with my customer and will try to take a look.


Steven
Steven Clementi
HP Master ASE, Storage and Clustering
MCSE (NT 4.0, W2K, W2K3)
VCP (ESX2, Vi3, vSphere4, vSphere5)
RHCE
NPP3 (Nutanix Platform Professional)