HPE Community
BladeSystem - General
1753747 Members
4787 Online
108799 Solutions
New Discussion юеВ

Re: Virtual Connect Not linked/degraded

 
Hans Minten
Occasional Contributor

тАО06-16-2008 05:38 AM

тАО06-16-2008 05:38 AM

Virtual Connect Not linked/degraded

Hi,

got a question about virtual connect concerning settings. we got 2 VC in our blade system configured as linked/Active linked/standby.

now we tested the system and pulled out the first VC (linked/Active) and the system went down. but put that aside because we plugged the module back in the system and now it is saying not linked and the sytem had a degrade warming.

is there a thing we can do abou this so that the 1st VC module is linked/active again and not the status not linked.

Thanks
0 Kudos
Reply
3 REPLIES 3
JKytsi
Honored Contributor

тАО06-16-2008 09:52 AM

тАО06-16-2008 09:52 AM

Re: Virtual Connect Not linked/degraded

Hi,
You can do a manual failover from the virtual connect manager GUI so You get connection back to primary VC-module.
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
0 Kudos
Reply
Hans Minten
Occasional Contributor

тАО06-24-2008 11:53 PM

тАО06-24-2008 11:53 PM

Re: Virtual Connect Not linked/degraded

Can you tell me in short how to do a manual failover for the virtual connect.

Thanks
0 Kudos
Reply
JKytsi
Honored Contributor

тАО06-25-2008 09:03 AM

тАО06-25-2008 09:03 AM

Re: Virtual Connect Not linked/degraded

Hi,

In VC manager --> tools--> reset and choose force failover.
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.