HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Virtual Connect and DMZ help

 
BrianDoyle
Trusted Contributor

Virtual Connect and DMZ help

Trying to get a Blade server to connect to a DMZ. Server has no mezz cards, just embedded NICs.
In VC, have a Shared Uplink Set of two ports in Interconnect Bays 1 and 2 connected to the same DMZ switch as the other DMZ servers. Vlan'ing is on the switch and VC, not on the server.

It has an Associated Network called "DMZ" with vLan ID 1

Server unable to ping any server in the DMZ.

Any advice?
2 REPLIES
pakm11
Advisor

Re: Virtual Connect and DMZ help

Start with server; check IP settings, snoop the interface to see which subnet it is on.
From VC manager, triple check ethernet networks with an eye on correct VLAN ID assignment. Server profile should be assigned correct ethernet network.
BrianDoyle
Trusted Contributor

Re: Virtual Connect and DMZ help

Took away the VLAN tagging and it worked straight away. It was uplinked to a layer 2 switch, i thought it was a layer 3.