- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Virtual Connect to Switch Speed/Duplex
BladeSystem - General
1753481
Members
4695
Online
108794
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-07-2009 02:34 PM
03-07-2009 02:34 PM
Virtual Connect to Switch Speed/Duplex
I have an HP c-7000 BladeSystem with two 1/10GB-F Virtual connect cards. I have all 8 ports connected into my core switch (a cisco 6509). On the switch I have it set to connect on vlan 10. Speed/Duplex is set to auto. I've set the virtual connect cards to communicate via auto. They don't connect. I've also tried every other setting. The only setting that works is when both sides are set to 100/full on both sides. I'd like to set them to 1gb/full in order to take full advantage of the bandwidth. Any suggestions would help.
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-09-2009 09:40 AM
03-09-2009 09:40 AM
Re: Virtual Connect to Switch Speed/Duplex
We have our Cat 3750's set to auto and in VC for the 1/10GB VC's its set to 1GB/Full in the SuS and Ethernet Network profiles.
Then for our ESX hosts we have the networking set to 1000/full.
This seems to wokr quite well for us.
Then for our ESX hosts we have the networking set to 1000/full.
This seems to wokr quite well for us.
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP