HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Virtual connect Blade Unknown

 
Aissa
Frequent Advisor

Virtual connect Blade Unknown

Hi all,

When i connect a blade 460G6 or change it from a bay to another one on the C7000 my Blades is shown as unknown.i have to restart VC so my Blades is see correctly.

Do you have any idea about that
2 REPLIES
JKytsi
Honored Contributor

Re: Virtual connect Blade Unknown

I would start by checking FW levels
- VC
- blade (BIOS,ILO)
- OA
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
Gerardo Arceri
Trusted Contributor

Re: Virtual connect Blade Unknown

Definitely, you need a firmware upgrade According to the following document:
http://h18004.www1.hp.com/products/blades/components/c-class.html

"Note 2: If you are using G6 ProLiant server blades in an enclosure (with or without G1 or G5 server blades), you are required to upgrade to the OAv2.51 compatibility column below. Using OA v2.51 MUST have the latest ROM and iLO versions installed. "


Regards, and don't forget to assign points.!