BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

WWN not showing up in VCM for VC-FC Moduels

placitasmd
Frequent Advisor

WWN not showing up in VCM for VC-FC Moduels

After flashing the VC firmware on a FC interconnect we no longer see the WWN values for the switches we are connected to. All is working fine; we just don't see the WWNs. If anyone has any ideas on why this may be and how to restore them, I would appreciate it. We updated from 1.32 to 1.40 on the FC modules and VCM went from 2.12 to 2.31. I have attached a screen shot if it is of any help
Mark E Duhamel
1 REPLY
WFHC-WI
Honored Contributor

Re: WWN not showing up in VCM for VC-FC Moduels

Hi plac,

We saw something similar in our environment. To resolve it we first re-seated both Onboard Administrator modules and the sleeve they sit in, then each fiber module, and finally each Ethernet module.

With redundancy in place this should not incur any outages to the blades as long as you wait for each interconnect module to return to service before re-seating the next.

good luck