HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

Wrap test on P-Class fibre?

 
Koopa
Frequent Advisor

Wrap test on P-Class fibre?

I have a BL25p G1 with a q-logic card installed. One of the fibre cables is showing errors at the MDS switch at the far end, and it disables the port. The second port on the card is working fine. The question is, can you do a wrap test on a port in the chassis and leave it running for a long period of time, so I can determine if the fault is in the enclosure, or if it's the fibre cable.

P.S. this blade is installed in a enchanced enclosure, and we have a Cisco GESM installed with the fibre bridge card installed in it.