HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

c7000 cisco blade Switch 3020

 
SOLVED
Go to solution
mo ali_1
Occasional Contributor

c7000 cisco blade Switch 3020

 

Hi i have a hp c7000 blade system and with it two cisco switches i have configured the oa and other parts of the enclosure but i am not sure about how i should configure the network switches, below are some of the concerns i have.

 

1. Do the blade switches require configuration or should i just connect it directly to my distribution/access switches (i have loop guard enabled on this switches).

2.if configuration is required what are the basic configurations required to get me up and started.

 

thanks in advance your replies.

2 REPLIES
Robert_Jewell
Honored Contributor
Solution

Re: c7000 cisco blade Switch 3020

How you should configure them is up to your environment and needs, right?

 

Here are some links to docs that should help:

 

http://h18004.www1.hp.com/products/blades/components/c-class-tech-installing.html

   Scroll down about 2/3rds and you will see the Cisco switches.

 

http://www.cisco.com/en/US/products/ps6748/tsd_products_support_series_home.html

 

-Bob

----------------
Was this helpful? Like this post by giving me a thumbs up below!
mo ali_1
Occasional Contributor

Re: c7000 cisco blade Switch 3020

Thanks, i also found a good document on bladesytem into cisco data center network architecture, which covers the different designs of deployment.