HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

c7000 ebipa blade ilo config

 
faulkkev
Occasional Contributor

c7000 ebipa blade ilo config

Is it correct that the ip of the OA and the ebipa ips for the blades and interconnects must be on the same subnet for OA to be able to open up a console? I have tested it both ways and I can manage them if they are all on the same subnet with OA but not if they are different.
2 REPLIES
James ~ Happy Dude
Honored Contributor

Re: c7000 ebipa blade ilo config

When a server blade or interconnect module is inserted into a bay that has EBIPA
enabled, that management port will get the specific static IP address from the Onboard
Administrator if that device is configured for DHCP. This is only possible when they are in the Same Subnet. I dont think otherwise is possible, If so, Ideas are most welcome.

Regards,
James.
faulkkev
Occasional Contributor

Re: c7000 ebipa blade ilo config

thanks I figured so but wanted to make sure as it calls for me to eat up 16 more ip's off our utility network per say.