HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

cClass OnBoard Administrator and GbE2c management

 
SOLVED
Go to solution
Claude Vatry
Occasional Visitor

cClass OnBoard Administrator and GbE2c management

Hello,
The Management Console access of the GbE2c from the OnBoard Administrator Gui is by default using http. What is the procedure for switching it to https? I have seen in the doc how to enable https on the switch and on the Onboard Administrator, but couldn't find how to change this Management Console link.
Many thanks!
2 REPLIES
HEM_2
Honored Contributor
Solution

Re: cClass OnBoard Administrator and GbE2c management

Claude:

I tested this here and the OA does not recognize an https mgmt console link for a GBE2c nor for a Cisco blade switch. I think this is because the OA doesn't really know what http access method it should use for each IO device it just assumes http. There needs to be an enhancement to the OA where it may query the IO device to determine the correct access method or where a user can manually configure the access method on the console link.
Claude Vatry
Occasional Visitor

Re: cClass OnBoard Administrator and GbE2c management

Thanks a lot for the information, that's more or less what I suspected.
So I understand with the current OA release, we have a coherency issue with the iLO remote access recommended practice.
Hopefully this will be enhanced in a newer version.