BladeSystem - General

changing Blade Card slot and virtual connect mapping

 
owahid
Frequent Advisor

changing Blade Card slot and virtual connect mapping

Installed Card :FLB Adapter 1: HP FlexFabric 20Gb 2-port 650FLB Adapter (installed in bay 1 ,bay2 "backview")
Blade Servers : ProLiant BL460c Gen9
Virtual connect : HP VC FlexFabric-20/40 F8 Module (installed in bay1,2 "BAck view")

Enclosure :  BladeSystem c7000 Enclosure G3

Installed Card currently map to bay1 , bay2  "back view "(which contain the two installed virtual connect devices)


I want to move this server blades to another enclosure but only bay 7,8 "back bays" will be available to install the Virtual connect.
My question : can I move that "FLB Adapter" installed card from its current slot to another slot so it will map to bay 7,8 instead of bay 1,2 , (so it will connnect to new bay which virtual connect will exist)

1 REPLY 1
Sebasbin
HPE Pro

Re: changing Blade Card slot and virtual connect mapping

 

Hi,

You cannot use the "FLB Adapter" on Mezzanine slot .As mezzanine 2 (3& 4 port on 4 port adapter )and mezzanine 3 only mapped to I/O bay 7 and 8

Please go through below link for the Device Bay Port Mapping Graphical View for c7000 Enclosure

https://support.hpe.com/hpesc/public/docDisplay?docId=a00047943en_us&docLocale=en_US

https://techlibrary.hpe.com/docs/enterprise/servers/BL460cGen9/BL460cGen9-setup/system_setup_overview/Setup.htm


Note: While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the company

Accept or Kudo