HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

cluster BL870c-OA login

 
kuzo_1
Occasional Contributor

cluster BL870c-OA login

I have a new c7000 with two servers blade to install with a cluster BL870c . but I have problem to the config of Enclosuer. where can I find the login of the OA. I did not see it on stiker to the enclosure. it is with license Key whom I am going to have him(it)?

KUZO
4 REPLIES
Steven Clementi
Honored Contributor

Re: cluster BL870c-OA login

On the OA, there is a pull out tab. It's gray graphite in color i think. Look on the back of the enclosure at the OA.

On the Tab is the default password and name.


Steven
Steven Clementi
HP Master ASE, Storage and Clustering
MCSE (NT 4.0, W2K, W2K3)
VCP (ESX2, Vi3, vSphere4, vSphere5)
RHCE
NPP3 (Nutanix Platform Professional)
Torsten.
Acclaimed Contributor

Re: cluster BL870c-OA login

Normally there should be a sticker with the login credential written on it. However, if you pull the OA (left is primary by default) the login is written on the bottom side.
If you pull and push it back, the other OA became active meanwhile.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
David Claypool
Honored Contributor

Re: cluster BL870c-OA login

If all else fails you can connect to the OA via a serial cable and do a password recovery. See the User Guide for details.
kuzo_1
Occasional Contributor

Re: cluster BL870c-OA login

Tanks