enable ebipa server 1-16 hangs..

[Damian O'Sullivan]

Hi guys,

When I try and "enable ebipa sever 1-16" on a OA and respond with YES it hangs. If I press control-C it returns properly ie:

OA1> enable ebipa server 1-16

Entering anything other than 'YES' will result in the command not executing.

Enabling EBIPA causes the iLOs in the bays that are enabled to be reset.

Are you sure you want to enable EBIPA for the specified device (iLO) bays? yes

< hangs here until I press Control-C>
EBIPA is enabled for device (iLO) bay # 1.
EBIPA is enabled for device (iLO) bay # 2.
EBIPA is enabled for device (iLO) bay # 3.
EBIPA is enabled for device (iLO) bay # 4.
EBIPA is enabled for device (iLO) bay # 5.
EBIPA is enabled for device (iLO) bay # 6.
EBIPA is enabled for device (iLO) bay # 7.
EBIPA is enabled for device (iLO) bay # 8.
EBIPA is enabled for device (iLO) bay # 9.
EBIPA is enabled for device (iLO) bay #10.
EBIPA is enabled for device (iLO) bay #11.
EBIPA is enabled for device (iLO) bay #12.
EBIPA is enabled for device (iLO) bay #13.
EBIPA is enabled for device (iLO) bay #14.
EBIPA is enabled for device (iLO) bay #15.
EBIPA is enabled for device (iLO) bay #16.

Any ideas? OA is 2.21 and ILOs are 1.50.

[Raghuarch]

sometimes command Enable EBIPA will take 10 to 20 seconds to complete. how long did you wait before pressing Control-C?

Is there any log messages in the OA syslog?