how to access blade c7000 OA using GUI

[Basheer_2]

Hello all,

c7000 blade.
able to ssh to OA.

how do I get gui access to OA.
tried http://IP-of-OA no luck.

Thanks for your help.

[Cederberg]

Hi.

sounds like either a hanged OA or the option for https has been disabled.

When you ssh to the c7000 chassi typ in "enable https" without the quotation marks. That enables the web access to the OA if it has been disabled.

[Jimmy Vance]

A little more info about your setup might help resolve quicker. Can you ping or ssh to the OA? Are you sure the OA is connected to a network?

[Basheer_2]

Hello Cederberg,

enable https
says

already enabled.

is there any port # I need to put after the http://OA-IP
https://OA-IP

[Adrian Clint]

No port numbers needed.

Have you verified its not the network, firewall or a browser proxy setting?

[Frank Gessner]

disable proxy on your browser.

[The Brit · Accepted solution]

Hi Basheer.

Be sure you are using the appropriate IP address,

Basic question:: Can you ping this IP Address (I assume YES)??

When you log in to the OA (via SSH) does it say that the "OA Role: Active"

If not, do a "show network" and check at the bottom that "Enclosure IP Mode: Enabled", it could be that you are attempting to connect to the Standby OA.

Dave

[marcus1234]

connect laptop directly to OA is access all okay via web now,
with browser explorer max version 7 for good measure.

what happens now..

[Johan Guldmyr]

Heya, have you looked in the front of the enclosure in the insight display? Is there an IP set?

[Johan Guldmyr]

Also, while you're in there, make sure that the OA Ethernet port have link :)