HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

how to reseat server management module bl -p

 
SOLVED
Go to solution
John Korschot
Occasional Contributor

how to reseat server management module bl -p

I just inherited several blade server enclosures some are working right, some not
On one in particular, when connecting to the ilo on the first blade enclosure it shows it as the 2nd in rack view. When connecting to a ilo on the actual 2nd enclosure it reports Management Module is Temporarily Unavailable

I found trouble shooting for this
http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?lang=en&cc=us&taskId=110&prodSeriesId=2510338&prodTypeId=329290&prodSeriesId=2510338&objectID=c00792656
and I have the cabling right and want to reseat the module but can not locate document on how to do this.
Can someone tell me how to reseat the module and any caveats? Are there any jumpers to set to tell the enclosure which one is which?
Thanks
John
4 REPLIES
Raghuarch
Honored Contributor
Solution

Re: how to reseat server management module bl -p

Hi Jhon,

Refer to Page 103 to reset the management module.
http://bizsupport.austin.hp.com/bc/docs/support/SupportManual/c00065042/c00065042.pdf


Regards,
Raghuarch
Raghuarch
Honored Contributor

Re: how to reseat server management module bl -p

Hi John,

If you want to reset the ILO of server.
There is a system maintenance switch in server it has iLO Security Override jumper switch enable it.

Refer to Page 28 of the below link.
http://h20000.www2.hp.com/bc/docs/support/SupportManual/c00212796/c00212796.pdf

Regards,
Raghuarch
John Korschot
Occasional Contributor

Re: how to reseat server management module bl -p

Thanks for the link to the p class chassis, I was not able to locate it myself. I'm working on this between other problems so it may be a day or 2 before I get this straitened out. Once I get this I have to clean up the labeling on the Cisco switches as well but I dont need help with that.
Thanks for you help
Raghuarch
Honored Contributor

Re: how to reseat server management module bl -p

:)
Forum Points are Appreciated.

Raguarch