HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

insufficient memory for cpqarray.sys

 
Troy Harrell
Advisor

insufficient memory for cpqarray.sys

I am build a BL460c blade server via Rapid Deployment pack. I receive "insufficient memory for cpqarray.sys" while the linux boot image is loading. I have upgraded the firmware, regenerated the linux boot image in RDP and called HP for advise. Still not fixed. Can someone tell me what is wrong?
5 REPLIES
Raghuarch
Honored Contributor

Re: insufficient memory for cpqarray.sys

Hi Harrell,

RDP had issues with Windows 2000, not sure with Linux? Which OS are u trying to install.

http://h18013.www1.hp.com/products/servers/management/rdp/knowledgebase/00000082.html


Regards,
Raghuarch
Troy Harrell
Advisor

Re: insufficient memory for cpqarray.sys

I am trying to deploy Windows 2003 x86. However, the RDP job never starts because of the insufficient memory error.
Raghuarch
Honored Contributor

Re: insufficient memory for cpqarray.sys

Hi Harrell,

if you are trying to install 2003 with service pack, there are chances you may see this,
have you tried installing just 2003, with out service pack.
Once the OS is up deploy the service pack.

Regards,
Raghuarch
Troy Harrell
Advisor

Re: insufficient memory for cpqarray.sys

"Insufficient memory for cpqarry.sys" appears before the initial deployment job to runs. The job I am running is "Deploy Proliant ML/DL/BL + Windows 2003 Enterprise + PSP {WinPE}.
Troy Harrell
Advisor

Re: insufficient memory for cpqarray.sys

To resolve or dypass the error, disable the on-board array controller in the system bios. Once the initial SAN boot build process has completed, re-enable to array and configure as necessary.