BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

nparstatus fail on rp7410

Fernando Boza
Regular Advisor

nparstatus fail on rp7410

I have 1 rp7420 and 1 rp7410
I get ignite from rp7420 and restore on rp7410.
But, on boot I get the following error on /etc/rc.log

CRDHP03 >/sbin/rc2.d/S602icod start
ERROR: The following low-level error occurred:

@4:Software error.[Error on ioctl.]No such device or address
ERROR: The following low-level error occurred:

@4:Software error.[Error on ioctl.]No such device or address
ERROR: The Instant Capacity (iCAP) Agent
was unable to reconcile the number of active
processors with the intended number of active
processors. For further information about
the Instant Capacity status, run icapstatus (1m).


I have determined that the error is in the parstatus:

CRDHP03 >parstatus
Note: No action specified. Default behavior is display all.
CIM_ERR_FAILED: HPNPAR4:@4:Software error.[A time-out occurred waiting for a response from the IPMI request 6:1(NetFn:Cmd). status codes returned were -1:0:6(ioctl function return:cCode:errno).
]No such device or address
Note: Unable to get any HP_NParComplex information.
Error: Unsupported platform.


how can I correct it?
1 REPLY
Frauke Denker_2
Esteemed Contributor

Re: nparstatus fail on rp7410

Hello Fernando,
This sounds like a problem with WBEM. Check that the directory /var/opt/wbem/repository contains:
root#cimv2#npar or
root#cimv2#npar.db (11.31)
If WBEM works in general (check with command osinfo) you might need to (re-)install the NPar-Provider.
Frauke