HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

p-class blade iLO cable connections settings and problem

 
dihung
Occasional Contributor

p-class blade iLO cable connections settings and problem

Hi All,

We have 3 x blade p-class enclosure installed with enhanced backplane components, i.e. a iLO port in the rear.
I have 2 questions about the settings and problems of iLO.
1. We connect iLO port to the front 2 x ports of switch A and B, i.e. 3 of 4 ports in the front switch A and B connected to iLO ports of blade. Is it connection correct?

2. We found that we can ping the iLO port of blade server after set up iLO settings through "F8" during boot up. But we found the ping test connection will lost immediately when we try to open a browser and enter the blade server iLO ip to connect. Is there any suggestions?

Thanks a lot your help.

Best Regards,
Dic