HPE Community
BladeSystem - General
1752750 Members
5164 Online
108789 Solutions
New Discussion

Re: some errors in IML

 
SOLVED
Go to solution
b00genator
Occasional Contributor

‎02-20-2007 06:20 PM

‎02-20-2007 06:20 PM

some errors in IML

on BL20p G2 I get this error in the IML log:
Infrastructure Fault, Interrupt Error at Interconnect Blade B, Unknown
and
Infrastructure Fault, Interrupt Error at RJ45 10 East, Unknown
that the error could mean?
0 Kudos
Reply
1 REPLY 1
Oleg Koroz
Honored Contributor

‎02-21-2007 06:51 AM

‎02-21-2007 06:51 AM

Solution

Re: some errors in IML

can you update with more info:
type of interconnects at A and B side, cube modules ?
Enclosure firmware
can you reseat B side Interconnect and all modules ?
Any RED LED on the Management Module ?
swap Cube module from B side to any other enclosure or A side check if problem follow one of them
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.