Grayh,
Looks like your loading on a new box-fresh, and loading O/S on a bare system is not something everyone does and it can be quite stressful to do it the first time. There were a couple tips about this that I found and maybe it would apply in your case. I used the Search tool for "q_boot"
Here's a comment from one thread that mentioned on their new frame, which had multiple cells, there was in issue loading the O/S due to the version of Ignite while loading on frame with multiple cells. Here's what the fix was:
"..Guys, I posted this just to let everyone know the solution.
Our disaster recovery service provider ran across this quirk after upgrading to Ignite 7.1/7.2 with cell-based systems. Seems the multiple cells caused problems with the recovery (I don't know why, but it does). Sure enough, he reduced the system down to cell 0 only, and the Ignite worked. After the system was Ignited, he added back in cell 1. We were working fine at that point with the full system available."
Look at for details:
http://forums11.itrc.hp.com/service/forums/questionanswer.do?threadId=1152793&admit=109447626+1221060905449+28353475So maybe reducing down (even temporarily) to just cell 0; or maybe a newer version Ignite to load from.
Hope this helps you,
Rgrds,
Rita
