uplink C7000

[Broitmann]

Hi all
We have bought a second C7000 enclosure and I'd like to link it to the first one so we can manage both in one go.
I've propely cabled it, but I think there is a configuration to do somewhere.
Can anyone help?

Thanks

[JKytsi]

Hi,

Check OA firmware levels (should match) and check also the interlink cable (bottom enclosure to link up and top enclosure link down connectors)

No configuration needed.

[Raghuarch]

refer to page 7 it shows the rear Down link and up link locations.
http://h20000.www2.hp.com/bc/docs/support/SupportManual/c00698534/c00698534.p
df?jumpid=reg_R1002_USEN
Page 52 in the below Doc.
http://h20000.www2.hp.com/bc/docs/support/SupportManual/c00698286/c00698286.p
df?jumpid=reg_R1002_USEN

[Broitmann]

These are the docs I've used to cable it. I've checked and updated the firmwares so they are all to the same level.
Should I use a cross cable?
Currently there's no light on on the OA. Is it normal? will there be any when it's properly cabled?

thanks

[JKytsi · Accepted solution]

The interlink cable sockects will have light if everything is ok.

normal cable is used.

[Broitmann]

Well, finally it was simply the network cable which was out of order.

Thanks all!