HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
BladeSystem - General
cancel
Showing results for 
Search instead for 
Did you mean: 

virtual serial numbers on SAN-attached enclosures only?

 
WFHC-WI
Honored Contributor

virtual serial numbers on SAN-attached enclosures only?

Hi all,

I opened a case with support this morning since after updating Virtual Connect firmware to revision 2.01 I see the "Serial Number (Logical) Settings" is not available on some enclosures. (I have not used it yet so I am not sure if it was available before.) It seems the link only appears on enclosures that are attached to a SAN fabric and not those that have only VC-Ethernet modules. After some checking the support tech told me that this option is only present after installation and configuration of VC-FC modules.

Anyone have a clue as to why this would be? HP doesn't think that anyone would install a serial number sensitive application on a server that wasn't SAN-attached??