BladeSystem Management Software

Re: Brand new C7000 system won't connect to blades with error "Could not connect error (0xfffff

 
kvasko
New Member

Brand new C7000 system won't connect to blades with error "Could not connect error (0xffffffff)."

This is a brand new Gen9 C7000 blade system with 16 nodes. I am getting  "Could not connect error (0xffffffff). Wait a few seconds and try again." I have upgraded the OA to the latest version of firmware that I got from here (4.50
1 Oct 2015). The system shows 4.50 as the OA version. Any suggestions on how to get the console to connect to the KVM of the nodes?

http://h20564.www2.hpe.com/hpsc/swd/public/readIndex?sp4ts.oid=3923546&swLangOid=8&swEnvOid=54

1 REPLY 1
Robert_Jewell
Honored Contributor

Re: Brand new C7000 system won't connect to blades with error "Could not connect error (0xfffff

Your post is a week old, so I hope you are up and running by now!   But, where were you seeing this error message?  Were you able to get to the OA and see the blades?  Was this error from a blade console?

-Bob

----------------
Was this helpful? Like this post by giving me a thumbs up below!