HPE Community
BladeSystem - General
1753640 Members
5174 Online
108798 Solutions
New Discussion

Re: Failure on C7000. All blades were marked with a red "X".

 
JalilAukhadiyev
Occasional Visitor

‎06-03-2018 11:12 PM

‎06-03-2018 11:12 PM

Failure on C7000. All blades were marked with a red "X".

Hello!

We have blade chassic C7000, with nine ProLiant BL460c Gen8 blades. AOA firmware is 4.50 and blades firmwares are 2.30 and 1.30.

At one morning all blades in this chassic became marked with a red "X". We resolved it with "power off" - "power on" entire C7000. I attached Log of this AOA.

Can anyone help understend what was is that? Can we to avoid repeating this situation in the future?

Sorry for my English and thank you for any help!

0 Kudos
Reply
1 REPLY 1
Naresh_HPE
New Member

‎06-20-2018 11:00 AM - last edited on ‎06-21-2018 01:47 AM by

‎06-20-2018 11:00 AM - last edited on ‎06-21-2018 01:47 AM by

Re: Failure on C7000. All blades were marked with a red "X".

Hi @JalilAukhadiyev

The log snippet shows that there are no events recorded on OA syslog over 6 hours of time.

How many OA's have been populated on this enclousre. Could you please collect OA SHOW ALL and upload for the same.

Make sure, OA has been updated to latest firmware to avoid erratic behavior.

 

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.