BladeSystem Management Software

Failure on C7000. All blades were marked with a red "X".

 
JalilAukhadiyev
Occasional Visitor

Failure on C7000. All blades were marked with a red "X".

Hello!

We have blade chassic C7000, with nine ProLiant BL460c Gen8 blades. AOA firmware is 4.50 and blades firmwares are 2.30 and 1.30.

At one morning all blades in this chassic became marked with a red "X". We resolved it with "power off" - "power on" entire C7000. I attached Log of this AOA.

Can anyone help understend what was is that? Can we to avoid repeating this situation in the future?

Sorry for my English and thank you for any help!

1 REPLY 1
Naresh_HPE
New Member

Re: Failure on C7000. All blades were marked with a red "X".

Hi @JalilAukhadiyev

The log snippet shows that there are no events recorded on OA syslog over 6 hours of time.

How many OA's have been populated on this enclousre. Could you please collect OA SHOW ALL and upload for the same.

Make sure, OA has been updated to latest firmware to avoid erratic behavior.