BladeSystem Management Software

Integrated Lights-Out (iLO) Network configuration problem. "Check connectivity to iLO default gateway"

 
chuckk281
Trusted Contributor

Integrated Lights-Out (iLO) Network configuration problem. "Check connectivity to iLO default gateway"

Shashi had an ILO question:

 

************************

 

I have just mounted a C3000 blade enclosure with two BL495c G5 blades with Flex NICs and one Flex-10 module.

 

I have assigned the console IPs through EBIP method for all the modules/blades.  For all the interconnect modules the IP assigned properly, but for blades the iLO ip is not assigning.

 

The diagnostic  information shows the iLO network as “iLO Network configuration problem. check connectivity to iLO default gateway”

 

OA version is 3.11 (there are two OAs) and the in blades the iLO firmware version is showing as 2.0

 

Please anyone tell me how to solve this issue.

 

**************

 

Monty needed some more info:

 

***********************

 

So what gateway did you configure in the EBIPA configuration for the device bays?  iLO really needs a gateway address to be configured.

 

********************

 

More to follow............ Other suggestions?