BladeSystem Management Software

Onboard Administrator (OA) Power Delay not working

 
bouli3
Occasional Contributor

Onboard Administrator (OA) Power Delay not working

I'm testing power outage and automatic shutdown/startup of my c7000 enclosure and blades. I configured power delay settings in OA. After all server blades are down, I turn the power off. When turning the power on, OA starts all blades and interconnects immediately after the self tests without any delay. According to the OA User Guide the system log should contain: "PowerDelay has been initiated for the selected devices" which is missing in my case (log attached).

 

Active and Standby OAs both Firmware Version 3.30.

 

OA power delay config:

SET SERVER POWERDELAY 1 180
SET SERVER POWERDELAY 2 180
SET SERVER POWERDELAY 3 180
SET SERVER POWERDELAY 4 180
SET SERVER POWERDELAY 5 180
SET SERVER POWERDELAY 6 1
SET SERVER POWERDELAY 7 0
SET SERVER POWERDELAY 8 0
SET SERVER POWERDELAY 9 180
SET SERVER POWERDELAY 10 180
SET SERVER POWERDELAY 11 180
SET SERVER POWERDELAY 12 180
SET SERVER POWERDELAY 13 180
SET SERVER POWERDELAY 14 1
SET SERVER POWERDELAY 15 0
SET SERVER POWERDELAY 16 0