BladeSystem Management Software

Re: Upgrade a BL460c G1 firmware

 
Fabien_P
Occasional Contributor

Upgrade a BL460c G1 firmware

Hello,

I'd like to upgrade the firmware of multiple BL460c G1 servers.

Is it safe to use the latest SPP (2015.10.0) to upgrade these very old blades ?

Thanks,
Fabien

3 REPLIES 3
Torsten.
Acclaimed Contributor

Re: Upgrade a BL460c G1 firmware

SPP 2015.10 supports G6 to G9, so it will likely update the ILO only.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Fabien_P
Occasional Contributor

Re: Upgrade a BL460c G1 firmware

Thanks for your reply.

In fact the only thing I'd like to upgrade is the "Power Management Controller" of these blades, to fix this error on the enclosure's OA : "The power management controller firmware on this blade must be upgraded. Please see customer advisory c01668472."

Do you know if it can be upgraded through the SPP 2015.10 ?

Torsten.
Acclaimed Contributor

Re: Upgrade a BL460c G1 firmware

you probably need to add the .scexe file to spp, then you can use it

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!