BladeSystem Management Software

Using 6120XG as a switch layer for VC Flex10 in the same chassis...

 
chuckk281
Trusted Contributor

Using 6120XG as a switch layer for VC Flex10 in the same chassis...

Louie had a customer question:

 

**********************

 

We have a requirement to use 2 x 6120XG in a c7000 chassis as switches for VC Flex10 in the same chassis.

 

So the 6120 switches will be used purely to allow VC Flex10 to attach to them externally (i.e. DAC cables from VC to 6120) and then for P4300s to attach to the 6120s as well through 10Gb DACs (P4300 has 10Gb NIC upgrade).

 

No servers will be attached internally to the 6120s i.e. they will be only drawing power (and management) from the chassis.

 

Is this supported?   Any possible issues in doing this?

 

The main driver for this design is that the customer is a Telco running DC power (the c7000 is a DC enclosure) and this is the easiest way for us to get switches into the environment without the much larger expense of adding external 10Gb DC powered switches just to get the P4300s attached (also any external switches would have to be Cisco).

 

The original configuration had the P4300s attached directly to VC Flex10 (I know this is not supported) – we are trying to remedy the situation by adding the 6120s as the switch layer between VC and the P4300s.

 

*****************

 

From Monty:

 

*****************

 

The Onboard Administrator will have no problem with putting ‘extra’ interconnect modules in bays that are not otherwise connected to server mezz cards.

 

**************

 

See any other issues that may cause problems? Any other suggestions for a solution?