BladeSystem Management Software

Re: Where to fing old ILO firmware for BL 890c i2?

 
ALe_3
Frequent Advisor

Where to fing old ILO firmware for BL 890c i2?

Hello everyone,

 I need to update the firmware of the enclosure but, before doing this I need to upgrade the ILO3 firmware of the BL 890 ic2 installed with HPUX 11 v3

 

 the current version is: 1.01 and I have read that it would be better to install the intermediate firmware before installing the latest available.

 

However on the HP driver section there is only the latest.

 

Do you know if there is a site that stores the old firmware for the BL890?

Once I found an HP ftp site but It was really difficult to find what I needed as the firmware was referenced not with a "human"  readable code (i.e.. ILO firmware version x.y) but with the code (cp000etc)  and I had to download everything, uncompress the file and understand if it was what I was searching for. However I could not find the firmware I needed.

2 REPLIES 2
Torsten.
Acclaimed Contributor

Re: Where to fing old ILO firmware for BL 890c i2?

You should download the latest revision, start HPSUM and update everything on the blade. No steps needed.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
ALe_3
Frequent Advisor

Re: Where to fing old ILO firmware for BL 890c i2?

Thanks for the suggestion