HPE Community
BladeSystem - General
1753646 Members
6134 Online
108798 Solutions
New Discussion

Cisco 3020 blade switch question on trunking.

 
chuckk281
Trusted Contributor

‎03-02-2010 11:28 AM

‎03-02-2010 11:28 AM

Cisco 3020 blade switch question on trunking.

Tim had a customer question:

 

Can you set ports 1-16 to ‘switchport mode trunk’ (802.1q trunks) on the Cisco 3020?   These are the ports that map to the server blades.  I looked over the Cisco documentation and it seems that this would be allowed (like on any Cisco) but just wanted to check with the experts….

Reis had a short and sweet reply:

yes, works fine.

Anyone worked with the Cisco 3020 blade switch? Comments? Suggestions?

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.