BladeSystem Network Blades

HP 1:10Gb Ethernet Blade Switch, not getting IP via EBIPA service OA

 
Jose1974
Occasional Contributor

HP 1:10Gb Ethernet Blade Switch, not getting IP via EBIPA service OA

HI Guys:

I am trying to configure the HP 1:10 Ethernet Blade Switch, to get ILO management IP via EBIPA from OA, for this I have enabled DHCP by command using console access, I enabled if 256 (management interface) and DHCP service on switch:

 

HP 1:10Gb Ethernet Blade Switch
 

Current idle CLI timeout: 5 minutes
System will reset on crash
Use of BOOTP for configuration currently enabled 
Use of DHCP for management interface configuration currently enabled  <---- DHCP is enabled which is supposed to overwrite any IP configured for management interface (if 256) but that is not my case.
 
Switch is not getting ILO IP, which is supposed to be assigned by OA using EBIPA.
 
Here is the config and the messages:
 
>> sw1-bay5-c7000 - Configuration# diff
=> Pending configuration
 /c/l3/if 256
        ena
        addr 0.0.0.0
        mask 0.0.0.0
        broad 255.255.255.255
 
If I try to enable interface once enabled DHCP, I get this message:
 
>> sw1-bay5-c7000 - IP Interface 256# ena
Current status: disabled
New status:     enabled
>> sw1-bay5-c7000 - IP Interface 256# apply
Error: Invalid address for IP interface 256.
Error: Invalid address / mask pair for IP interface 256.
Error: Apply not done.  Use "diff" to see pending changes,
       then use configuration menus to correct errors.
>> sw1-bay5-c7000 - IP Interface 256# /
 
 
 

 

2 REPLIES 2
Jose1974
Occasional Contributor

Re: HP 1:10Gb Ethernet Blade Switch, not getting IP via EBIPA service OA

Hi HP community, any assistance you can add on this?

If I add IP manually to the interface 256 (management) it is not opening the web console, also I cannot telnet that IP.

Hope someone can help on this.

Kamalji
Frequent Advisor

Re: HP 1:10Gb Ethernet Blade Switch, not getting IP via EBIPA service OA

Refer installation guide . 
https://support.hpe.com/hpsc/doc/public/display?sp4ts.oid=5039543&docLocale=en_US&docId=emr_na-c01055384 

If this was working earlier and now stopped working ..would suggest to contact HPE support and open a support ticket to investigate and fix . 

If this is a installation time error refer installation guide to configure . 
https://support.hpe.com/hpsc/doc/public/display?sp4ts.oid=5039543&docLocale=en_US&docId=emr_na-c01055384 

From the serial console interface, be sure that the switch IP address is configured and valid on the network.

Thank You!
I am a HPE employee

Accept or Kudo

__________________________________________
Was the post useful? Click on the white KUDOS! Thumb below to say Thank You!