BladeSystem Network Blades
cancel
Showing results for 
Search instead for 
Did you mean: 

IP configured on bladecenter switch management ports wrongly mounted on fa0 ethernet management port

 
ginigangadharan
Occasional Contributor

IP configured on bladecenter switch management ports wrongly mounted on fa0 ethernet management port

Dear Experts,

 

I was configuring BladeSystem c7000 Enclosure G2. During that, we configure management IP for blades (iLO IP) and bladecenter switchea (Interconnect bays) via EBIPA GUI tab. But we have faced below issue for some deployments; when we assign IP for bladecenter switches, its mounting on Ethernet Management port (fa0) instead of Switch management port. And we will be in stuck to configure remaining things as reserved IP already taken by fa0 which is not editable in express setup/GUI screen. Any idea about this issue ?

 

Enclosure :  BladeSystem c7000 Enclosure G2

Bladecenter Switch : Cisco Catalyst Blade Switch 3120X for HP

 

switch-ip.png

 

Thanks in advance.