BladeSystem Network Blades
cancel
Showing results for 
Search instead for 
Did you mean: 

ProCurve 6120XG Management URL http://0.0.0.0

 
SOLVED
Go to solution
Paul-OSK
Occasional Visitor

ProCurve 6120XG Management URL http://0.0.0.0

I have a c7000 enclosure with 4 active bays 1,2,5 and 7. All four have ip addresses assigned to them but 2 of them (bays 1 and 5) have a management URL of http://0.0.0.0 and show a "Current Address" of 0.0.0.0. I have disabled and re-enabled the blades and even reset the system. I cannot get the EBIPA to bind to the management URL. Has anyone seen this before? 

5 REPLIES
Torsten.
Acclaimed Contributor
Solution

Re: ProCurve 6120XG Management URL http://0.0.0.0

I have seen a similar problem, after a firmware update of the procurve and OA it went away.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Paul-OSK
Occasional Visitor

Re: ProCurve 6120XG Management URL http://0.0.0.0

We are using firmware version Z.14.26 96 for the 6120XG

Torsten.
Acclaimed Contributor

Re: ProCurve 6120XG Management URL http://0.0.0.0

How about the OA firmware?

Latest version for the switch is Z.14.28: http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=de&prodTypeId=3709945&prodSeriesId=4015939&swItem=MTX-03307b3b5c794e459ed6567e5c&prodNameId=4015940&swEnvOID=1005&swLang=13&taskId=135&mode=5

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Paul-OSK
Occasional Visitor

Re: ProCurve 6120XG Management URL http://0.0.0.0

The OA is running 3.30 Apr 19 2011

Paul-OSK
Occasional Visitor

Re: ProCurve 6120XG Management URL http://0.0.0.0

Firmware update did the trick. Thanks very much.