Simpler Navigation for Servers and Operating Systems
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
BladeSystem Network Blades
cancel
Showing results for 
Search instead for 
Did you mean: 

VLANs - Cisco Catalyst Blade Switch 3020 for HP

david_pol
Occasional Visitor

VLANs - Cisco Catalyst Blade Switch 3020 for HP

HI,

 

I'm new to the Cisco Catalyst Blade Switch 3020 for HP. How do you assign 1 port to more than 1 VLAN? On the older GB22c switch I enabled tagging and could assign a port to multiple VLANs. I can'f find the cisco way to do this.

 

Thanks.

2 REPLIES
Cederberg
Honored Contributor

Re: VLANs - Cisco Catalyst Blade Switch 3020 for HP

The cisco way to use more than one VLAN per port is called trunking.

 

There is a chapter in this document that describe it indepth. The chapter is called "Configuring VLAN Trunks" and if you just want the commands search for "Configuring a Trunk Port".

 

http://www.cisco.com/c/en/us/td/docs/switches/blades/3020/software/release/12-2_55_se/configuration/guide/3020_scg.pdf

Highlighted
david_pol
Occasional Visitor

Re: VLANs - Cisco Catalyst Blade Switch 3020 for HP

Thanks for the the last post. So I setup my vlans, and the 2 ports connected to the blades are set to 802.1Q trunk. I have set the "trunks allowed" to the 2 vlans.  Problem is - I can only ping from the port I set the "Native VLAN" to.  I attached a picture. any ideas?

 

Thanks,

 

Dave