Simpler Navigation for Servers and Operating Systems
Completed: a much simpler Servers and Operating Systems section of the Community. We combined many of the older boards, so you won't have to click through so many levels to get at the information you need. Check the consolidated boards here as many sub-forums are now single boards.
BladeSystem Network Blades
cancel
Showing results for 
Search instead for 
Did you mean: 

vPC on Cisco Nexus vs. NON vPC

Highlighted
chuckk281
Trusted Contributor

vPC on Cisco Nexus vs. NON vPC

Joe asked about a CIsco function.

 

******************

Does anyone have a document showing the disadvantages (bandwidth, failover, etc.) of connecting VC modules to Cisco switches using vPC.

Thanks

 

************************

 

Reply from Dan:

 

****************

 

Here is a quickly revamped diagram I have used on here before.

Now there are 2 tabs at the bottom for Active/Passive vs Active/Active designs.

 

I also pulled out the Upper and Lower mentions that were specific to the customer I created this for.

 

Past that, the main differences I see are in the Active/Active design.

With vPC and cross connects (the diagonal uplinks), losing an upstream switch will cut the bandwidth in half on both sides.

With/Without vPC and NO cross connects and SmartLink enables, losing an upstream switch will cause half the NICs to go down but the other half would still have full speed on uplinks.

 

***************

 

Comments or question?